Multipurpose Plasticized Expanding Grout Admixture.
Domestic, Commercial and Industrial.
Fine Brownish Grey Powder.
Groutex 200 is an admixture for site batched cementitious grouts where a reduced water/cement ratio and positive expansion is required. Applications include bed grouting, duct grouting, non-shrink infilling and jointing.
Other Key Features
Gaseous expansion system compensates for plastic shrinkage and settlement in properly designed cementitious grout. Reduced water/cement ratio in the grout mix ensures low permeability and long term durability in service. Gives high grout fluidity with low water/cement ratio, thus making placement or injection of the grout easy. No metallic iron content to corrode and cause staining or deterioration due to rust expansion in the grout. Composition allows high early strength development in grouts, without the use of chlorides.
200g for preparing 50kgs cement based grout slurry (recommended water content is 20 to 22 ltrs – that yields 36 ltr grout slurry) or 100 kgs cement-sand ( 1:1 ) based grout slurry (recommended water content is 22 to 24 litres – that yields 57 ltr grout slurry).
Instruction For Use
For best results a mechanically powered grout mixer must be used. It is essential that machine mixing capacity and labour availability is adequate to enable the grouting operation to be carried out continuously. The selected water content should be accurately measured into the mixer. Slowly add the cement (and sand if required) and Groutex 200. Mix continuously for 5 minutes, making sure that a smooth even consistency is obtained.
Areas to be grouted should be prepared to ensure substrates are clean, sound, and then pre-wetted. The unrestrained surface area of the grout must be kept to a minimum. Place the grout within 20 minutes of mixing to gain the full benefit of the expansion process. Adopt usual placing or pumping procedures ensuring a continuous operation.
On completion of the grouting operation, any exposed areas which are not to be cut back should be thoroughly cured by means of water application or wet hessian.
02 (two) years from the date of manufacturing.
Package & Pricing
|Unit||Retail Price For ( INDIA )||Shipper ( In Pcs. )|
Value For Money Factor
It costs only Rs. 80=00 to yield grout slurry of 50 kgs cement ( 36 ltr. ) or grout slurry of 100 kgs cement – sand ( 1:1 ) mixture ( 57 ltr. ).